How to Order DIY Recone Kits

If you send us the numbers on the magnet or frame of your speaker, we might know what DIY recone parts you need.  If we do not have a listing of your parts, we will need these measurements for each recone part.

  1. Inside diameter (ie 1.518, 2.018- use a caliper)
  2. length of former
  3. length of windings
  4. layers (dual or single)
  5. impedance
  • Cone:
  1. depth of cone (from throat to top of surround)
  2. type of Surround (cloth roll, accordion cloth edge, butyl rubber, paper, foam)
  3. type of body (ribbed, smooth, polypropolene)
  • Spider:
  1. width
  2. height
  • Dustcap:
  1. diameter
  2. material (fiber, felt, screen)

Most Recone kits come unassembled.  There is 1) voice coil, 1) spider, 1) cone with attached surround, 1) dustcap, 1) pair of tinsel leads, 1) gasket or gasket set if applicable plus centering shims and instructions. (certain models come with two spiders)

Additionally you might need: glueself mixing epoxy, or latex (cloth surrounds only if not already applied)

Note: Some parts could require modification for your application.